Surely no one would have predicted that drapery makers would incorporate these simple, classic, and affordable metal bends in their designs. With a pin hook, you may hang pocket rod curtains in your living room and change it into a stylish place.
With a little practice, you can hang pocket rod curtains in the classic manner. In addition to your curtain and pocket rod, you’ll need a hook for hanging a pin hook, snap-open shower curtain rings, and a fabric marker.
Bạn đang xem: How To Hang Pocket Rod Curtains With A Pin Hook? Step-by-Step Tutorial
All you have to do is use the materials to attach, pin, hook, conceal, and hang. To prevent the pin from pushing through your cloth all the way, insert it through the back end of the fabric. Once you’ve hung the curtain, attach the opposite end of the pin hooks to the curtain rings and you’re all set.
Use Pleater Tape
Rod-pocket panels are easily transformed with pleating tape, also known as header tape, applied to the top edge. Pocket and corded pleating tapes are available. Small vertical pockets are sewed about an inch apart on the pocket tape. Curtains are held in place by the prongs of pinhooks, which move upward into the pockets. Corded pleating has pockets and two parallel cords that run horizontally along its length. Plucking the cords causes the fabric to be pleated.
Like pocket tape, pinhooks can be attached to corded tape. As an alternative to header tape or sewing machines, you may simply slip your pinhooks up into the pocket of the rods. When hanging a swooping curtain, pinhooks should be spaced around 4 inches to 6 inches apart, and 7 inches to 12 inches apart for a flat curtain.
Pin Hook Curtains
According to The Home Digs, pinhooks come in a variety of varieties. Curtain panel edges are best served by a single or double-pronged curtain hook. With pleated curtains, the gathered and flat portions alternate, and the flat areas are usually towards the ends. The prongs of multi-pronged pinhooks can be spread apart to form pleats. You can use the pleating tape to create tight pleats in the fabric by inserting your prongs into every other vertical pocket. For broader, looser pleats, omit two pockets, and so on.
Fit a 1/2-inch metal ring from a jewelry-making kit onto each of the snap-open shower curtain rings you purchase. Use a small metal ring as a pinhook and slide the shower curtain rings over the rod. To conceal the traverse rod, use long-neck pinhooks with a hook put about half an inch below the top of your curtain; short-neck pinhooks have a hook set 1 to 2 inches below the top border of your curtain.
Different Types of Pleats
You can choose from a variety of pleats to tailor the design of your curtains once you’ve decided on the appropriate type of pleating tape and pinhooks. With no flat region between pleats, pencil pleats are a single, continuous row of pleats. You’ll need a lot of pinhooks and pleating tape if you want to make this with rod pocket curtains.
Traditionally, French pleats have three pleats packed together tightly, with a considerable amount of flat curtain between each grouping. Unlike French pleats, the double pleat has only two pleats. Like pencil pleats, cylinder pleats are rounded rather than sharply folded and can be single or clustered.
Tips and Hints
To prevent your curtain from ending in a pleat at the very edge, use the glossy, small marks sewed into the tape to identify the center of the flat spaces. Once the pleats are in place, don’t cut off the excess cording. Sew it to the pleating tape using a needle and thread, or insert it between the pleating tape and a piece of curtain fabric in the pocket. Curtain panels can be laundered or dry cleaned and then re-pleated using this method.
When you’re counting off spaces, use a fabric marker to mark where the four-prong pinhooks go so you can easily find your spot again if you’re interrupted or distracted. Using a 12-inch piece of buckram, roll the cartridge pleats into a cylinder and slide it into the cylinder.
Things You Will Need
- Plaster of Paris
- Pinhooks
- In a matter of seconds, the shower curtain rings can be snatched open
- Textile brand
Pocket rod curtains
With a rod pocket curtain, draperies can be hung in a more classic, traditional, and common manner. When utilizing pocket rods to hang curtains, the fabric itself is usually stitched with pockets for the rods. You next hang the pocket rod by securing it to the rod and adjusting it to your preference.
Slipped-on drapes with pocket rods can be a pain to open and close, especially if you have a lot of drapery. Pin hooks may be a better option for you if you frequently open and close the door.
Pin hooks
Xem thêm : How To Measure For Window Curtains? Complete Step-by-Step Guide
Rather than sewn-in grommets, traditionalists prefer the classic aesthetic of a drapery pin hook instead. Modern curtain hanging methods are excellent, but many homeowners and interior designers prefer the stylish and refined appearance that comes from sticking with more traditional methods.
These hooks have been used for a long time in the fishing industry. Customers trust them because they’re long-lasting and don’t damage your drapes in the process of serving as a drapery pin hook. The draperies are kept safe and mobile with this device, allowing you to open and close them as you wish.
Step-by-step procedure
As soon as you’ve gathered all of the necessary tools, such as a curtain pin hook and rings, rulers, and fabric markers, you’re ready to start.
Step 1: Lining the curtain
Make sure the fabric’s reverse side is facing you when lining up the curtain’s top. Use pleater tape at the top edge if that works for you. You can use it to make adjustments to your rod-pocket panels. Small, one-inch-diameter vertical pockets are known as pocket tapes. As a result, the pin hook may fit into the upward pocket with ease.
Step 2: Measure the intervals.
As soon as you have your drapes or a curtain in place, grab a marker and a ruler to start the timer. Ideally, you should set a numerical gap between each hook attachment point. There’s a risk that it could get untidy and messy otherwise.
You should also make sure that your marks are uniform and even throughout. Make sure the placements aren’t too low or high on the curtain hem by paying attention to their height.
This step would be unnecessary if you had chosen to stitch pocket tapes rather than attach pleater tape. Finally, we may move on to the next phase.
Step 3: Attaching the hooks
Choose pleated curtains and you’ll be pleased with the results. You should attach each of your pin hooks according to the timetable. Spread the prongs out by putting one at every other pocket tape if you’re using vertical pockets. For loose pleats, leave out two pockets.
The sharp edge of your drapery pin hook should be tucked under a sufficient amount of cloth to ensure its safety. Make a concerted effort to coat the entire pin hook. In order to avoid puncturing the front of the material, push through the rear lining with the straight edge. Use the back of the curtain to keep it safe and hidden.
Step 4: Curtain rings
Check to see that it is not too loosely attached with all of your hooks in place. When you have all of your fabric gathered, start by attaching the pin hooks to the curtain rings. You should be able to see your hook if you followed the third step correctly.
Using the hooks, fasten the rings to your curtain rings and slip them onto the rod’s pocket. Consider the diameter of the hooks on the pins. This will help you. You can hang your curtain a half-inch lower with long-neck pin hooks. A pin hook with a short neck can disguise the traverse rod by about an inch or two.
Step 5: Hang your rod
The hooks and rings have been fastened. It is time to attach the final to the rod. Set the rods carefully on the curtain brackets after they have been lifted. To ensure that the rod is completely centered and not leaning toward either edge, you can modify its location.
Tricks To Hang A Rod Pocket Drape With A Pin Hook
For a variety of reasons, home-made curtain designs are becoming increasingly popular. However, a lovely drape won’t do much for the aesthetic appeal of your house if it isn’t properly hung. Your plain curtain can be elevated to something remarkable by properly hanging these curtains. Let’s get started now.
Choose The Pin Hooks:
Xem thêm : How To Add Blackout Lining To Existing Curtains? Complete Step-by-Step Guide
Using pin hooks on rod pocket curtains requires matching the shape and size of each pin hook. You can tighten any open pins by pressing them a little. By doing this, the hooks will remain attached to either the curtain ring or the rail.
Spacing The Pin Hooks And Making The Pleats:
You may make this style of curtain using a clever approach. To put it another way, the pins must be evenly spaced, and the number of pin hooks must be odd. When constructing a pinch pleat, remember to attach a pin to the curtain hook.
For a total of 5 pleats, you’ll need 5 pin hooks, plus 1 pin for each end. Total of 7 hooks. Use a marker to indicate the midpoint of the pin hook spacing to ensure it’s even. Make a mark on each side of the curtain where you fold it in half. Pin hooks should be inserted after the second repetition of the maneuver.
Insert The Pin Hook:
Every point should be marked with a pin hook inserted back along the seam line. You can place a pin hook into the screw eye over the ring to determine how far from the top edge the pin hook should be inserted. Finally, you should place the ring’s bottom to the top of the header.
The bottom of the pin hook should be marked with a marker pen or pencil so that it may be easily removed. It’s here, exactly, that the pin hook belongs. Place the pin hook exactly where you marked it. You can see the pin lying inside the pleat if you make one.
Measure the distance from the top of the heading to the bottom of the pin hook to insert the rest of the pin hook. Pin hooks can be inserted once you’ve measured the suitable length.
Insert Pin Hooks At The End Of Headings:
Make a mark with a pencil or pen at the same distance down from the top as you did at the top. Insert the pin hook about one centimeter from the side of the garment. For further stability, use buckram. Ensure that the pin cannot be seen from the right. To finish off the header, do the same thing on the other end.
THESE ADDITIONAL ADVICES.
If your window is 60 inches wide and your curtain panel is 60 inches long, it will not look well. Because the fabric is delicate, it’s going to hang straight and scant, and it won’t cover much of the ground. As a result, the appearance of your curtains will be enhanced if they are one and a half times the width of the window. Make sure your draperies have enough volume.
When it comes to hanging drapes, most people like to do so right on the window trim, just above eye level. An overly wide gap between the ceiling and moldings makes the room appear smaller. If you want to make the space feel more open and spacious, hang your curtain rod close to the ceiling.
Use a longer curtain rod to give the illusion of a wider window by displaying the entire length of the rail. A new look will be brought to your living space by this. It will also let in a lot of natural light.
Professional Tips
Pin hooks are compatible with a variety of pleating tapes. Before you apply the pleater tape, take some time to decide on the look you want to achieve. In addition to loose, tight, and reverse pleats, there are many other options. With any luck, you’ve now mastered the fundamentals of using a pin hook to hang pocket rod curtains.
Take your time and follow the instructions to ensure that your curtains look as though they’ve been sewn together.
Nguồn: https://iatsabbioneta.org
Danh mục: Curtains
